Polish Radom AKM 7.62x39 80 Percent Receiver 100% Made in Poland w/ rails and center support installed, fully heat treated, and Black Oxide Finish


Item Number: 9370
Price: $69.95
Average Rating
ratingratingratingratingrating
See Reviews

Description

These Polish 7.62x39 80% receiver blanks are 100% made in Poland using original Polish Radom Military tooling and parts. This is the closest you can get to an original military receiver! These 80 percent receivers already have both the rails and center support fully installed, and they are fully heat-treated with a black oxide finish. These are considered 80% complete so they do not require a FFL dealer since they are missing the axis pin and safety selector lever hole. We sell the AK-Builder blank drilling fixture to complete the last remaining holes. These are 1.0 mm and work with all the AKM-47 parts kits we sell on the website! The first picture shows 2 receivers but each order includes 1 We are not shipping these to NJ currently due to the new bill that was signed

Product Reviews

Product Reviews

Rate This Product:
or Create a Review
(12 Ratings, 4 Reviews) Average Rating:
ratingratingratingratingrating
ratingratingratingratingrating
Buy a couple of these
Derek Jimenez (Pico Rivera) 7/23/2019 7:15 PM
These are really nice receivers. For the price you can't beat them. The finish is nice and they come heat treated. AK expert Mishaco says that these are the same receivers that are used on the WBP Fox rifles. I bought two and at $69 each it was hard to pass up. If you are wanting to stock up on AK parts then don't pass these up. Such a great deal on quality, Polish receivers.
ratingratingratingratingrating
Perfect!
Al (Maine) 7/10/2019 12:48 PM
These are by far the nicest receivers I've seen in years, especialy at this price! Now I need to order a few more so I can rebuild my older guns... :)
ratingratingratingratingrating
best value, hands down
John (Iowa) 7/10/2019 9:25 AM
I used to order from childersguns and then switched to recreatorblanks for my builds. But these are 100% Polish authentic with minimal effort to build.. and priced lower than than any other equivalent competition. And yes, you will need good drill bits to finish these. I have tungsten carbide, but black oxide bits should be fine
ratingratingratingratingrating
Cut to the chase...
Mark (Arizona) 7/9/2019 8:09 AM
I have not seen a better baseline unit for a build. Form, fit, finish, and cost are excellent. Rails are spot welded in already with 4 spots each side. You will have to use cobalt or carbide to drill the needed holes since it has already been hardened but minimal work is needed to put these units together. A great value in my opinion.